ADR246 Infusion Resin is a low-viscosity epoxy system designed for resin infusion. The long working time allows resin to travel through large laminates as well as create a stronger finished product.

Features:

• Excellent fibre wet-out helping to reduce dry spots and voids
• Low viscosity for smooth resin flow during infusion
• High mechanical strength after cure

Quick Tips

• Mix thoroughly for 3–4 minutes, scraping sides and bottom
• Choose the right hardener for your project.  This pack is supplied with the ADH162 hardener which is designed for infusion (low viscosity and long gel time)

• Material: Epoxy Resin and Hardener
• Mix Ratio: 4:1 by weight
• Working Temperature: 18-25C
• Pot Life (100g @ 20°C): ~6 hrs 40 mins
• Thin Film Cure (@20°C): ~10 hrs
• HDT after 7 days: ~50°C
• Ultimate HDT (with post-cure): ~80°C
• Recommended Post Cure: 24 hrs @ 20°C + 12 hrs @ 50C

—

A few words on safety:

• Use in well ventilated area with the right PPE including gloves, eye protection and mask.

• Full SDS available upon request.

• Infused composite hulls and decks for boats
• Kayaks and canoes

—