This pack combines the ADR246 epoxy resin with 162 Hardener to make a low-viscosity epoxy resin designed for infusion. Perfect for composite builds where strength, clarity, and controlled flow matter.

• Excellent fibre wet-out for void-free laminates
• Low viscosity for smooth resin flow during infusion, reducing air entrapment and improving fibre wet-out.
• High mechanical strength after cure
• Moisture resistant for marine and outdoor applications
• Post-cure capable for ultimate heat resistance

• Mix Ratio: 4:1 by weight
• Pot Life (100g @ 20°C): ~6 hrs 40 mins
• Thin Film Cure: ~10 hrs
• HDT after 7 days: ~50°C
• Ultimate HDT (with post-cure): ~80°C
• Recommended Post Cure: 24 hrs @ 20°C + 12 hrs @ 60°C

Quick Tips

• Mix thoroughly for 3–4 minutes, scraping sides and bottom
• Keep temperature controlled for infusion period
  • 18–25°C
  • Avoid working in direct sunlight or near heat sources
• Post-cure for maximum heat resistance
  • After initial cure, follow the recommended schedule:
    • 24 hrs at room temp + 12 hrs at 60°C for ultimate heat resistance and mechanical properties.

—

A few words on safety:

• Wear gloves and eye protection.  Minimum.
• Work in a well-ventilated area.

• Infused composite hulls and decks for boats
• Kayaks and canoes
• High-performance sporting gear (surfboards, paddles)
• Structural composite panels
• Custom carbon fibre laminates

—