Tooling Resin - NZ Fibreglass

Product

SKU N/A Category Polyester Resin & Kits

Our toolinr resin for moulding HPH 2040 is a pre-filled polyester tooling resin with low styrene content for moulding.

Formulated for manual application/ roller brush application
Hardens very well at room temperature both with 1 layer of MAT and with 4 or more layers of MAT applied wet on wet.
Suitable for the production of large surfaces and also for the production of moulds used in infusion process:
Available in 25kg size.

How to use:

Mix well before use.
Wet out one layer of chopped strand mat (CSM) using a brush.
Remove all air bubbles using a roller.
Quickly wet out three layers of CSM on top of first layer.
Allow the resin to harden.
Wet out four layers of CSM. Wait for resin to harden.
Continue wetting out up to four layers at a time until you get the desired thickness.

Technical note:

RS2040 has a low exothermic peak, a low volumetric, low linear shrinkage and high thixotropy that allows you to work quickly without dripping
RS2040 has a low styrene content allowing for low styrene emission.